CornerFix

When building a shelf as a DIY project, it is quite difficult to work while holding two boards in an L shape. This jig was made to make that task overwhelmingly easier.

In general, drilling a pilot hole before driving a screw (coarse-thread screw) makes the work go more smoothly. Notches are cut so you can see the board thickness, so there is no need to measure the drilling position.

For the "board thickness" value, board thickness + about 0.5 mm seems suitable.

Since you need a left and right pair, mirror the downloaded model in your slicer application to create the opposite-side model, and 3D print them as a pair.

[Parameters] Thickness: thickness of the board used Length: outer dimensions Height: height Rib Thickness: thickness of the ribs

can each be specified individually.